AudiManual.ru

Cylinder head bolt sequence and torque (Audi A2)

Replace cylinder head bolts. Tighten bolts in sequence -1...10- in 4 stages as follows: screw in bolts by hand until they stop. Tighten to 30 Nm. Tighten 90°. Tighten 90°.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Audi A2: Engine repair

Next articles

Finishing the cylinder head sealing surface
Cylinder head — design description
Removing and installing sealing shaft on gearbox side
Removal and installation of a flywheel
Replacing the crankshaft seal
Engine speed sensor
Intermediate shield installation
Sealing flange and flywheel — design description
Checking the Timing Belt Tensioner for the Associated Drive
Checking the toothed belt tensioner for the main drive

Removal and installation of cylinder head
Camshaft housing — design description
Removal and installation of the camshaft housing
Removal and installation of camshafts
Valves — design description
Valve seat processing

Similar articles on other Audi car models:
Cylinder head — removal and installation Audi 80 B3 (1986-1991, petrol)
Cylinder head — removal, inspection and installation Audi 100 C3 (1982-1990, diesel)
Lubrication of door latches and lock cylinder Audi A3 Type 8L (1996-2003)
Cylinder Head Gasket Faults Audi A4 B5 (1994-2001, petrol)
Cylinder head — 1.8-I engine (125/150 hp) Audi A6 C5 (1997-2004)
Left cylinder head cover Audi A8 D2 (1994-2002)
Cylinder head Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)

AudiManual.ru © 2017-2024 · Mobile version · Feedback · Sitemap: EN BG BY UA RS HR RO PL SK HU · Site search · News and articles
80 B2 · 80 B3 petrol · 80 B3 · 80 B4 · 100 C3 diesel · 100 C3 petrol · 100 C3 · 100 C4 petrol · 100 C4 · A3 Type 8L · A4 B5 petrol · A4 B5 · A4 B6 petrol · A4 B6 · A6 C4 · A6 C5 · A6 C5 Allroad · A8 D2 · Q5 Type 8R · Audi A2 · 0.759