Diesel engine lubrication system 1.2L car Audi A2

Engine lubrication system — design description
Instruction. If large amounts of metal chips or metal dust in the engine oil were found during repairs in the engine, the lubrication channels must be...

Removal and installation of the oil pan
Withdrawal Remove the engine hood. Remove engine cover -arrows-. Remove the noise shield located below, to do this, disconnect the crankcase breather hose....

Oil pump and crankshaft frame — design description
Oil pump and crankshaft frame: 1. Cylinder block 2. Oil injection nozzle for piston cooling, note the installation position: Screw the oil injection nozzle...

Removal and installation of the oil pump
Withdrawal Remove oil pan. Remove screws -arrows-. Unlock 5 fasteners and remove the oil separator. Press chain tensioner -arrow- and secure with locking pin...

Oil Filter Holder — Design Description
Oil filter holder: 1. Cover, tighten to 25 Nm 2. O-ring, replace 3. Remove the oil filter insert from the cover; when replacing the filter, replace the seal....

Removal and installation of the holder of the oil filter
Withdrawal Remove the engine hood. Remove engine cover -arrows-. Remove the noise shield located below, to do this, disconnect the crankcase breather hose....

Removal and installation of the oil pressure sensor
Withdrawal Remove the engine hood. Unplug electrical connector -arrow- for oil pressure sender -F1-. Unscrew the oil pressure sensor. Installation Install in...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: