Withdrawal
Pic. 16–60. Roof-mounted interior rearview mirror: 1 - mirror; 2 - finishing the base of the mirror; 3 – mirror base; 4 - wire; 5 - mounting plate; 6 - shaped upholstery; 7 - finishing of shaped sheathing; 8 - blocking pin
Detach the front part of the upholstery shaped trim 7 (pic. 16–60).
Disconnect the electrical connector of the wire going to the mirror.
Using a screwdriver blade, press the latches and separate the base 3 of the mirror from the mounting plate 5 on the left side.
Remove the mirror.
Installation
Before installing the mirror, check that the blocking pin 8 is in the correct position.
Mount the right side of the mirror base 3 on the mounting plate 5.
Press the left side of the base until it locks into place with the locking pin.
Connect the electrical connector and install the molded trim.
Visitor comments