Vehicle clutch and drive shafts Audi A4 B6, gasoline

Power Transmission — Design Description
The power train consists of a gearbox, clutch and final drive. In order for all its components to interact well with each other and transmit the power produced...

Clutch — design description
Manual transmission models have a hydraulically actuated single plate dry clutch with asbestos-free linings and a dual plate flywheel. Vehicles with a...

How the clutch works
Clutch control. The clutch release lever is actuated by the hydraulic system. The system compensates for clutch wear automatically, meaning it does not require...

Clutch test
The slipper clutch begins to show itself when accelerating in top gear. The motor rotates quickly, but the speed does not increase. The following is a method...

Is the clutch disengaging correctly?
If the gearshift process is accompanied by a rattle and crackle, then in most cases this means that the clutch is not disengaging well. The following describes...

Clutch Primary Cylinder Replacement
When carrying out the work described below, take care not to get brake fluid into the battery section and onto the gearbox located underneath. Brake fluid has...

Clutch Slave Cylinder Replacement
1. Mount the front of the car on the goats, remove the lower engine cover. 2. Turn away from the working cylinder the pressure head hydraulic pipeline. Be...

Bleeding the hydraulic clutch
In workshops, air from the hydraulic clutch drive is removed using a special device. With some skill, the air can be removed independently and without great...

Clutch fault indicator
Clutch fault indicator

Main gear and axle shafts — design description
The gearbox transmits the converted engine torque through the small and large (leading) gear wheel to the main gear. The main drive housing is screwed to the...

Noises in the axle shafts of the car
The service life of the axle shafts also depends on the way you drive. Avoid full throttle when turning the front wheels, and avoid starting off with spinning...

Checking the cuffs on the axle shafts
1. Place the front end on the trestle, the wheels must not touch the ground. When checking the cuffs of the hinges 1, pay attention to the tight fit of the...

Dismantling and installation of articulated shafts
You need an assistant to do this job. The outer joints are filled with grease G 000 603 and the joints «tripod» - grease G 000 605. 1. Remove the wheel trim....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: