Ignition System Specifications Total information Type of ignition system: ADP engine (1595 cm 3 ) — Bosch Motronic 3.2 AHL engine (1595 cm 3 ) — Simos ADR engine (1781 cm 3 - Bosch Motronic...
Ignition system — general information The Bosch and Simos ignition systems described in this chapter are combined with fuel injection systems and form with it a combined engine control system based...
Ignition system — check Attention! The voltages generated by the electronic ignition system are much higher than the voltages. produced by conventional systems. When working with the...
Distributor — removal, inspection and installation Note: This paragraph only applies to ADP motors. Withdrawal 1. The distributor is installed at the rear of the engine on the left and is driven by the upper...
Ignition timing — check and adjustment A distributor is installed on the ADP engine, the initial ignition timing can be adjusted, however, it is better to entrust this work to a dealer who has the...
Ignition system sensors — removal and installation 1. Most control system sensors are designed to control the operation of both the ignition system and the fuel injection system. Specific sensors for the...
Slider — removal and installation 1. Unhook the spring clips and remove the distributor cap. 2. Pull the slider off the distributor shaft. If provided, remove the dust cover. 3. Examine...
Diesel engine glow plug heating system Glow plugs Consumption current - 8 A per candle Tightening torques for threaded connections Nm Glow plugs - 15 To facilitate cold starts, diesel models are...
Glow plugs — removal, inspection and installation Examination 1. If a malfunction occurs in the system, the check can be carried out by replacing it with known-good elements, but it is still worthwhile to...