Introduction to the manual for the Audi 80 B2 This manual is a manual for the maintenance and repair of Audi vehicles «80» models «L», «GL», «GLS», «GLE», «GTE», «Formel E», «CLAN Base»», «CL», «SS», «GT»...
Passport data of the car Nameplate The nameplate is affixed to the right side panel in the engine compartment. It indicates the make, type, serial number, weight and code number of the...
Lifting and towing a car Climb Using the jack from the driver's tool kit Road jack installation locations are indicated by markings on the underside of the body at the front and rear...
General requirements for car repair The main part of malfunctions of mechanical components and assemblies during operation occurs due to friction processes, deformation of elements, aging of the...
Controls and instrumentation 1 - side ventilation nozzle; 2 - switch for fog lights and rear fog light (when installed in the first (a fixed position turns on the fog lights, if installed;...
Starting a cold engine Set the gear lever to neutral position. FZ and EP engines Fully depress the accelerator pedal and slowly release it (in the cold season, press the pedal...
Hot engine start FZ and EP engines Operate the starter without pulling the carburetor choke cover handle. If the engine does not start, turn on the starter again by lightly...
Starting the engine from an external battery If your own battery is severely discharged, it is possible to start the engine from the battery of another vehicle. In this case, proceed as follows: make sure...
Engine lubrication system Oil sump Before each trip or every 500 km, check the oil level in the engine oil sump with an oil dipstick. The oil level must be between the marks «max» And...
Coolant temperature The coolant temperature is controlled by a dial gauge. While the engine is cold, the pointer arrow is at the bottom of the scale, the control lamp for the...
Checking the coolant level On engines with an expansion tank built into the radiator After the engine has cooled, remove the cap from the radiator and check the coolant level, which...
Vehicle power system Fuel filter Replace the fuel filter every 30,000 km. Air filter Every 15,000 km of run, remove the filter element of the air filter and blow it with compressed...
Vehicle ignition system Engines with contact ignition system Periodically check the gap between the breaker contacts and the cleanliness of their working surface. The gap between the...
Clutch and gearbox Clutch Every 20,000 km, check the free play of the clutch pedal, which should be about 15 mm. Transmission The oil in the gearbox is filled for the entire life...
Vehicle running system Front wheel drive Every 15,000 km of run, check the tightness of the protective covers of the constant velocity joints and the wheel drive shafts. Steering...
Vehicle braking system Checking the level of brake fluid in the brake system Regularly check the fluid level in the brake master cylinder reservoir. If a sharp drop in the fluid...
Vehicle electrical equipment Control lamp of a charge of the rechargeable battery The control lamp of a charge of the storage battery lights up at inclusion of ignition and dies away after...
Interior ventilation and heating The ventilation and heating controls are located in the middle of the instrument panel and include (see photo): two levers «A» to adjust the direction of the...
Vehicle Specifications Wheels Depending on the configuration, the wheel rims can be disc, stamped steel or light alloy. Rim Dimensions: 5Jx13; 5½J13; 6J14. Tires Tires are radial,...
Body Checkpoint Diagrams Explanations for Body Control Point Diagrams Body checkpoints are labeled A, B, C, etc. Each diagram has a table in which the dimensions of the corresponding...